Concrete floor installation in Agoura Hills CA - a dry, flat slab under your floor
Old floor cracked, uneven or chipping, or a new room needs one? We build concrete floors on a packed base, poured and cured right.
- Licensed and fully insured.
- Free estimates at your property.
- We reply within 1 business day.
What goes into a new concrete floor in Agoura Hills?
Concrete floor installation in Agoura Hills means we form, pour, finish and cure a flat slab for a room, an addition, a studio or a shop, so it stays level under your flooring or serves as the finished floor itself.
Most calls start with a plan, like a new room, an addition or a garage floor that's cracked and uneven and has to come out. The price moves with the size of the floor, how much digging and base work the ground needs, how much steel goes in, how it's finished and how easy it is to get a truck close. The schedule turns on the weather on pour day and the cure time before flooring or anything heavy goes on, so the slab should come early in your plans. We're licensed and fully insured, and your written estimate breaks out each of those pieces for your floor.
How we handle concrete floor installation
We start by digging out to firm ground and packing the subgrade, the soil and gravel the slab sits on, in layers, because a base that's only raked level settles and takes the floor with it. If tile, wood or a coating goes on top, we watch the moisture layer closely, the sheet under the slab that keeps ground moisture out of your flooring, and keep boots off it until the pour, since even a small hole can let a lot more moisture up through the slab. We set rebar, the steel that holds the slab together, then pour early before the midday heat can leave a weak, dusty top, and screed and trowel it flat. We cut control joints, shallow cuts that give the slab a place to crack where we choose, as soon as it'll take the saw, and then we protect it while it cures, the slow hardening that gives concrete its strength. If a budget has to give somewhere, I'd rather you skip a fancy finish than cut the base, because nobody sees the base on day one and it's what decides whether the floor stays flat.
A new floor usually meets other concrete at its edges. Where a room or shop opens to the yard, our crew can build concrete steps at the door in the same project, and if the room sits by the pool, we can pour concrete pool decks so the levels line up at the doorway.
A slab for tile, wood or vinyl
This suits a new room or addition where flooring goes on top, because the moisture layer and a flat, true surface matter more than looks. We trowel it smooth and flat so your installer isn't grinding down high spots later.
Bare concrete as the finished floor
This works for a studio, a laundry or a modern room when you want the concrete itself to be the floor. Staining or sealing is extra work, so tell us at the estimate if you want color or a sheen.
Shop, storage or outbuilding floor
This suits a workshop or storage floor that takes rolling tools, shelving and heavy loads more than furniture, so we usually plan more steel into it. If it opens outside, we can give the doorway a broom finish, a light texture that keeps it from getting slick.
If your framing or flooring is already on the calendar, call now so the cure fits the schedule. We reply to every call and message within one business day.
What happens after you call about a concrete floor?
Here's how a concrete floor job runs with us, from the first call to the final walkthrough. I'm the one you talk to at the start and the one on site with our crew until it's done.
Call or send a message
Call (747) 219-1796 or use the form and tell us about the room and what you have in mind. We get back to you to set a time for me to come out.
I look at the site
I come out myself to check the ground, the access and where water runs around the slab, and you get a written estimate that spells out the prep, drainage, steel, joints and curing so you can see what your money covers. If the job needs a permit, an engineer or a scan first, I tell you at that visit.
We build from forms to finish
I'm on site with our crew the whole build, from setting forms to the last trowel pass. Before we start, you'll know when the floor can take foot traffic and when it's ready for flooring.
Walk the finished floor together
We walk the floor with you before we pack up and go over what the slab needs from you while it cures. Our work is backed by our satisfaction guarantee.
Get a written estimate for your new concrete floor
Send the form and we reply within one business day to set a time for me to come out. The estimate is free, done at your property and in writing, with no pressure to book.
(747) 219-1796What shapes concrete floor installation in Agoura Hills
Agoura Hills builds to the state's building and residential codes, as the city has adopted them. We check with the building office for your address before we start, and if your floor needs a permit, we tell you at the estimate and apply for it before any work begins. The county's soil rules also say that when soil holds a high level of soluble sulfate, a salt that eats at concrete, the concrete touching it has to be protected, such as with the right type of cement, and if that applies to your lot we plan the mix around it.
State rules say a contractor can ask for or take no more than $1,000 or 10 percent of the total contract price as a down payment, whichever is less. We're based in Agoura Hills and pour floors the same way in the cities around it on both sides of the county line, including Thousand Oaks and Calabasas.
Concrete floor questions we hear in Agoura Hills
How much does a concrete floor cost per square foot in Agoura Hills?
A concrete slab in Los Angeles usually costs about $7 to $14 per square foot, and that's the market's range, not our quote. Reinforced slabs cost more per square foot than unreinforced pads, and those usual prices leave out staining or stamping. Your written estimate gives the figure for your floor, with the prep and steel broken out.
How long does a new concrete floor take to cure before I can use it?
You should be able to walk on a new slab within 48 hours, and it's wise to wait about a week before putting heavier loads on it. Concrete takes about a month, 28 to 30 days, to fully cure, so plan move-in and heavy use around that, and we'll talk through how it fits your flooring date.
Will my new concrete floor crack?
Some random cracking is normal in any slab, even with joints cut close together, and steel won't stop it. What properly sized and placed reinforcement does is keep those cracks tight, so at the estimate I'll show you how we plan to reinforce your floor.
Who is allowed to install a concrete floor in California?
Flat concrete work like this falls under the state's concrete contractor license, which covers forming, pouring, placing and finishing it. Someone without a license can only take a job of $1,000 or less, and only when it needs no permit and they have no one working for them on it. The state licensing board sets those rules.
What is the best way to keep moisture from ruining flooring on a concrete slab?
The best protection is a proper moisture layer sitting right against the underside of the slab, since that's where it protects flooring and coatings most. Plain polyethylene sheeting was used under slabs in the past, but it shouldn't be considered for moisture protection, so if a covering is going on top, ask any contractor how the layer will be placed.
Does hot or windy weather affect pouring a concrete floor?
Yes, because wind makes heat and low humidity harder on fresh concrete, so a windy, sunny day calls for stricter precautions than a calm, humid one. It's usually a summer problem but can happen any time of year, and if pour day looks wrong, I'd rather wait a day than pour something I don't trust.
Concrete work that often goes with a floor
If the new room opens toward the pool, a deck poured at the right height keeps the doorway even and sends water away from the house.
A floor that sits above the yard needs a safe way down, and steps poured with even risers keep anyone from catching a toe at the door.
Call about your new concrete floor
Have the floor size in square feet and the flooring you plan to put on top ready when you call (747) 219-1796, so we can talk through what the slab needs underneath.